XLR Cable and Microfiber cloth are great. Packaging was 19/20, I do have a minor scratch on my device but I needed it urgently so I didn't return it. All my queries were responded to, promptly and to satisfaction. 10 day delivery during lockdown is amazing. But the Xenyx mic preamp has a low EIN so you can still use dynamic microphones - but I'd suggest using condenser microphones. This isn't terrible - but you have to be really careful with gain-staging and make sure you have a quiet room to start out with so that it's not too noisy. It also records only in 16-bit, which is again theoretically limiting for the dynamic range. I measured it and it's around 85 dB for my unit, this is 15 dB lower so I checked the ADC chip that this device uses and it is the Coolaudio V2902 - the dynamic range for which is stated to be 89 dB - thus confirming my doubts. Dynamic range - The one stated on the spec sheet is 100 dB, this is a lie. there's also a direct monitoring option) you'll have to use Equalizer APO and copy the channel you are receiving input in to the other side as well.
![behringer um2 driver windows 10 behringer um2 driver windows 10](https://i.ebayimg.com/images/g/aOAAAOSwtPNbIi37/s-l300.jpg)
Behringer um2 driver windows 10 Pc#
Windows - Both inputs are mono in this audio interface and Windows just doesn't get that - it forces you to use 2-channel, 16 bit integer and allows you to toggle only between 44.1kHz or 48kHz, which means you'll have to make sure that whenever you are recording on your DAW or OBS, you set the input to Mono!! In case you want to monitor through your PC (don't. Then again if you have multiple interfaces from this lineup (say you have the UMC202HD as well) then you are better off with the ASIO4All driver. () This works but it was a pain to set up as I had to do quite some research lol, but this driver works better.
Behringer um2 driver windows 10 drivers#
Drivers - The Behringer Website tells you to download the ASIO4All drivers for this interface, which is noisy and not the best option (personally), you'll have to do some digging up to find the old drivers they used to make for this lineup. Also, the phantom power switch is at the back of the interface which may or may not be convenient for you. No shielding from any electronic/RF interference as well so if you use USB mice, chargers etc near it - expect to hear some artifacts. Fully plastic build - Cheap price, cheap build - to a point that it's scary that it'll break anytime. Audio output is GREAT (both from the RCA output and quarter inch headphone jack. Feature packed - Xenyx pre-amp, phantom power, gain control for I/O, direct monitoring This makes it serious value for money, but to achieve this price point - Behringer did cut some corners that you should be aware of.
![behringer um2 driver windows 10 behringer um2 driver windows 10](https://images-na.ssl-images-amazon.com/images/I/810nTQDbWKL._SL1500_.jpg)
Instead of buying the small USB Interfaces - this is much better as it gives you the Xenyx Pre-amp, almost 48V of phantom power (if you are using condenser microphones), control over input and output gain, and direct monitoring. Like the title suggests, buy the Behringer UM2 only and only if you are on a very tight budget.